How to Sync Remote and Manifold on the Air Lift WirelessONE Part # AL25980

Updated 07/30/2018 | Published 07/29/2018

Question:

My compressor and relay works but the manifold does not send a signal to close relay when I increase pressure for my bags either the remote . Also if it is the manifold can I get a new one through warranty? System isnt a yr old yet.

asked by: Josh

Expert Reply:

It sounds like the remote and manifold on your Air Lift WirelessONE part # AL25980 have been somehow disconnected from one another. If this is the case then I recommend first changing the battery in the remote and then checking all the power and grounds to make sure they are secured and in woking order. Once this is done you will then need to resync the remote to the manifold which can be done by following page 12 in the instructions manual which I have attached for you.

If any of the components are not functioning properly then you would need to contact the manufacturer for warranty claims.

expert reply by: Conner L