Dimensions of the Holes in the U-Bolt Plate for 2-1/2 inch Trailer Axles with 2 inch Springs
Updated 09/14/2011 | Published 09/13/2011
Question:
Item # 117878 What are the exact measurements between the holes center to center? Also what is the thickness of the plate? Thank you
asked by: Perry O
0
Expert Reply:
I pulled one of the # 117858 U-Bolt plates out of stock and measured the center to center bolt hole spacing for you.
From the center of one bolt hole to the next, from side to side, the measuremsnt is 2-5/8 inches. From center to center front to back the measurement is 3-1/4 inches.
I posted a photo that I added all of the dimensions to for you to review.
expert reply by:
Robert G
0
click to enlarge
Product Page this Question was Asked From
U-Bolt Plate for 2-1/2" Diameter, Round Trailer Axles with 2" Wide Springs
- Trailer Suspension Parts
- U-Bolt Plates
- Camper
- Car Hauler
- Utility Trailer
- 7500 lbs
- Round Axle - 2-1/2 Inch
- 9/16 Inch Diameter
- Redline
more information >
Continue Researching
- Q&A: How Do I Measure Axle Spread for Upgrading The Trailer Equalizers?
- Q&A: What is Thickness of CE Smith U-Bolt Plate part # CES95FR
- Q&A: Where Should Rear Hanger Location be for Slipper Springs
- Q&A: Recommended Replacement Seal For A Tri Tec T-23972 Seal
- Q&A: Replacement U-Bolt and Plate for Trailer with 2 Inch Square Axle
- Q&A: How To Choose The Correct Leaf Spring U-Bolt Diameter Size On A Trailer Axle
- Q&A: Can Spring Perches on 3,500 Pound Axle be Moved
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern