Endcap Recommendation for Yakima Fourtimer When Reduced Down to TwoTimer

Question

Question:

Hi, I just received my hitch and Yakima Fourtimer bike rack. Its all installed and works great! However I do have a question about the bike rack and the end cap/bottle opener. The rack can be used in either a four bike or 2 bike configuration. When in the four bike configuration the mast has an endcap/bottle opener to keep water from coming in the mast. However in the two bike configuration it has no end cap and the cap for the extra two bikes is too small to fit. Im wondering if the end cap for the two timer is bigger and would fit the opening when it is the two bike configuration. Thanks!

asked by: Michael M

0

Expert Reply:

When you have your Yakima Fourtimer part # Y02469 reduced down to a TwoTimer you could use the replacement endcap/bottle opener part # 8880528 and you'd be set.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 6

Hi Jerry, For your 2025 Kia Sorento PHEV you would need the Curt Trailer Hitch Receiver #C37RV for the trailer hitch. The right light kit for your Sorento is going to depend on a few factors. For models with the tow package, like you stated you have,…

view full answer...

Answer 7

Hello Lou, thanks for reaching out. The hitch pin you are looking for is the etrailer D-Shape Anti-Rattle Locking Hitch Pin for Benton Hitch Accessories #e43JR. This will work with the Benton #B54VR bike rack you mentioned, as well as the #B54FR,…

view full answer...

Answer 8

Hey Alan, the Curt hitch part #C94WR that you referenced is a confirmed fit for your 2025 Hyundai Tucson and the recommended install method is to remove the lower bumper panel and leave it off. There might be a way you could remove the panel and…

view full answer...

Answer 9

Hey Loyd, nearly all roof rack setups for top channels will fit the Yakima channels you have on your cap. Rhino Rack has complete kits for this that include their HD crossbars with the part #Y01-140B-NT which comes with 65 inch long crossbars.

view full answer...

Endcap Recommendation for Yakima Fourtimer When Reduced Down to TwoTimer

Product Page this Question was Asked From

Continue Researching