Replacement Velcro for Lund Tonneau Covers

Question

Question:

I have a Lund tonneau cover that needs new Velcro on the rails. The Velcro measures 11/2 inches wide and the truck is a short bed Tacoma. Can you help. Thanks

asked by: Don

0

Expert Reply:

Although we do not carry Lund tonneau covers or their replacement parts we do have velcro strips that are 1-1/2" wide in the Replacement Velcro Strip part # A30474. The velcro is 17" long which should be more than enough for your 2009 Toyota Tacoma. It is designed to be used with Access tonneau covers but that is not to say it cannot be made to work for you.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Thanks for reaching out Kaiya, happy to help! For the 1998 Chevy C1500 Stepside, drilling is not required to install the Pace Edwards Full-Metal JackRabbit Retractable Hard Tonneau Cover #311-FMC2576. On Stepside models, the cover uses the factory…

view full answer...

Answer 4

I'm going to need you to measure the width of the Velcro strip of your Access tonneau cover. If the width his 1-1/2 inch you'd need the part #A30474, if it's 1 inch you'd want the part #A60270, or 1-1/4 inch part #A20790.

view full answer...

Answer 5

We have replacement tonneau cover Velcro that is exactly 1-5/16 inches wide with the Truxedo part #TX1115174 which would fit your rails. It can be cut down shorter too as it is 80 inches long.

view full answer...

Answer 6

The Replacement Velcro Strip for Access Tonneau Covers #A30474 installs on the rails. It is 17 feet long x 1-1/2" wide and is compatible with Access Original, Lorado, and Lo Rider tonneau covers.

view full answer...

Answer 7

The Replacement Support Bow part #TX578101-BOW measures 62-1/4" long from end to end. This bow is designed to be used with the TruXedo Lo Pro QT Soft Roll-up Tonneau Cover part #TX578101 which is a fit for the following: 2004 - 2007 Ford F-150…

view full answer...

Answer 8

The Replacement Adhesive Velcro Strip #A20790 is 16' long x 1-1/4" wide, and I believe that's what you were referring to by hook portion, and yes it is correct. We do not carry Lund tonneau covers or their replacement parts so while I…

view full answer...

Answer 9

Hey Dan, thanks for the information! We've actually ran into this exact situation before with the Chevy tonneau covers. The Replacement TruXedo TruXport Shur-Bond Hook-And-Loop Fastener Strips for 6-1/2' Beds item #TX1117876 can be used…

view full answer...

Replacement Velcro for Lund Tonneau Covers

Product Page this Question was Asked From

Continue Researching