Can Race Ramps be Placed Side By Side to Load Motorcycles onto a Trailer
Updated 06/06/2018 | Published 06/04/2018 >
Products Featured in This Question
Question:
I build high end motorcyces which are low to the ground - I thought I could use your ramps by placing them together in the center of my trailer ramp to provide me a ride on ramp to the trailer?
asked by: Martin A
Expert Reply:
For vehicles that are low to the ground the longer the ramp is the better because the amount of lift is more gradual over a longer distance. If you like the Race Ramps we have # RR-TR-8XL which are 6 feet long so for every foot of ramp the height increases by about 1.4 inches up to the total of 8 inches.
But you would know the best height and length to use based on the height of the trailer floor from the ground and the amount of ground clearance the bikes have. You could certainly place the ramps side by side if needed though you may need to fabricate something to keep them from separating while you are on them.
On another note my wife says I can't buy a motorcycle but she never said anything about someone giving me a motorcycle (hint hint)!
Product Page this Question was Asked From
Race Ramps Trailer Loading Assist Ramps - 6" Lift - 45" Long - Qty 2
- Car Ramps
- Loading Ramps
- Car Hauler Ramps
- 6 Inch Lift
- 3000 lbs
- No Attachment
- 14 Inch Wide
- 45 Inch Long
- Foam
- Race Ramps
more information >
Continue Researching
- Q&A: Replacement Recommendation for Dexter Axle Grease Seal K71-305-00
- Q&A: Replacement Stereo Upgrade Recommendation for Drive EEDV06 in RV
- Q&A: Replacement Oil Bath Hub Body and Cap for a UFP Oil Bath Hub w/ a 1.98 Hub Bore
- Q&A: What Is The Recommended Lug Nut Torque On 7,000lb Axles?
- Q&A: Replacement For 15 lb 20 Inch Extended Gas Shock
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Temperature Settings For The Furrion RV Refrigerator # FCR14ACBQABL
- Article: Trailer Lighting Requirements
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch

