Instructions for Replacing a 2.5 x 2.5 Heavy Duty RV Slide-Out Gear Pack
Updated 05/18/2018 | Published 05/17/2018
Question:
how to replace the gear block on slide out. I have been under and see the block just need to know if the 2 long bolts that go thru the block will let it drop where I can replace if necessary.
asked by: Edward J
Helpful Expert Reply:
I will be happy to explain the replacement instructions for Lippert Components 2.5 x 2.5 Heavy Duty RV Slide-Out Gear Pack # LC123356.
The exact instructions are as follows:
In the event a gear pack needs to be replaced, follow these steps:
1. Run slide-out room half way out.
2. Place a jack under the inner arm of the slide-out.
3. Jack room up just enough to remove pressure off the gear pack.
4. Remove drive bolt from the cross shaft.
5. Remove bolts which hold the gear pack assembly in place on the outer rail.
6. Drop out the damaged gear pack.
7. Install the new gear pack.
8. Install bolts to hold gear pack assembly in place on the outer rail.
9. Install cross shaft and bolt.
10. Gear pack assembly does not need to be torqued down, only adequately and securely tightened.
Product Page this Question was Asked From
Replacement Gear Pack for Lippert RV Slide-outs w/2-1/2" x 2-1/2" Arms - Heavy Duty
- RV Slide Out Parts
- Gears
- Gear Pack
- Lippert Above-Floor Slide-Out Systems
- Lippert Through-Frame Slide-Out Systems
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: led
- Search Results: awning
- Search Results: dometic awning
- Shop: etrailer 12V Power RV Patio Awning - 20' Wide - 8' Projection - 4-Layer Vinyl - Black Fade
- Shop: Replacement Gear Pack for Lippert RV Slide-outs w/2-1/2" x 2-1/2" Arms - Heavy Duty
- Video: Review of Dometic RV Toilet Parts - Replacement Flush Ball Kit - DOM65FR
- Search Results: dexter seal 10 36
- Shop: Replacement 18-Tooth Gear for Lippert RV Slide Out
- Video: Review of the Replacement 18-Tooth Gear for Lippert RV Slide Out
- Video: Breaking Down the Replacement Gear Pack for Lippert RV Slide-outs w/2-1/2" x 2-1/2" Arms
- Q&A: What Do You Need To Measure To Find The Correct Replacement Slide Out Gear Pack
- Search Results: 1036
- Shop: Replacement Gear Pack for Lippert RV Slide-outs -2"x3" or 3"x3" Arms - Standard
- Shop: LED Flood Light with Handle and Switch - 1,710 Lumens - Black Aluminum - Clear Lens - 12V/24V
- Shop: Low Profile LED Flood Light - Angled Beam - 1,000 Lumens - Surface Mount - Clear Lens
- Q&A: Is There Replacement Flush Ball for Dometic 310 Toilet
- Q&A: Which Flush Ball Fits Dometic 110 RV Toilet
- Search Results: grease seal 1036
- Search Results: trailer suspension parts
- Video: Let’s Check Out the Replacement Drive Head for Solera Power RV Awnings
- Video: All About the Replacement Drive Head Pin for Solera Power RV Awnings
- Video: Complete Breakdown of the Replacement Head Cover Fastener for Solera Manual Awnings
- Shop: Replacement Head Cover Fastener for Solera Manual Awnings - Qty 1
- Q&A: How To Get To the Holes To Install the Lippert Components Universal Slide Out Wear Pad
- Q&A: Can You Use An 18 Toothed Gear On Instead Of A 15 Toothed Gear On Your Slide Out
- Shop: Trailer Hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Shop: Brake Controller
on RV Slide Out Parts
