How to Install the Tekonsha Wiring Adapter Part # 3035-P on a 2018 Ford Explorer
Updated 05/09/2018 | Published 05/07/2018 >
Question:
I just get the Tekonsha Plugin wiring adapter 3035P for my 2018 Ford Explorer but the one on my Ford Explorer is a little bit small so the 3035P won’t fix in it. Any suggestions? Thanks
asked by: Miguel
Expert Reply:
The Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers part # 3035-P is a confirmed fit for a 2018 Ford Explorer. There are two ends on the adapter. A large square end with 6 pins that goes to the harness on the vehicle and a small rectangular end with 4 pins that goes to the controller.
The brake adapter port that you will plug this into is located under the driver dash panel usually around where the emergency brake would be. If the plug-in you found does not fit the harness then it is more than likely the incorrect port. There are several of these ports under the dash. The one you need could have a plug or taped to an existing harness. You will just need to keep looking until you find the one that matches the 6-pin square plug on the adapter harness.
Continue Researching
- Search Results: hitch balls
- Shop: Transmission Cooler
- Shop: Trailer Hitch
- Search Results: tongue weight scale
- Search Results: trailer hitch ball
- Search Results: trailer balls
- Search Results: hitch fabrication parts
- Shop: Front Mount Hitch
- Shop: etrailer Forged Steel D-Ring Tie-Down Anchor with Bolt-On Clip - 1/2" - 4,000 lb WLL
- Shop: Weigh Safe Ball Mount w/ Built-In Scale for 2" Hitches - 2" Drop - 10,000 lbs - Aluminum
- Shop: Big Truck Big RV Trailer Jack Foot Scale with Tongue Weight Gauge - 2,000 lbs
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Search Results: trailer tongue lock
- Shop: Big Truck Big RV Tongue Weight Scale for Trailers - 1,000 lbs - Fixed
- Video: Comparing Weigh Safe Ball Mounts
- Search Results: trailer lock
- Shop: Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets - Class V - Extra Efficient
- Shop: Brake Controller
- Shop: 2-5/16" Hitch Ball - 1" Diameter x 2-1/2" Long Shank - Stainless - 8K
- Q&A: Spare Tire Carrier Recommendation for a Featherlite Trailer
- Q&A: How to Install a Brake Controller in a 1992 Ford F150 and a 2002 Ford F-350
- Q&A: Front Mount Receiver Hitch for a 1993 Ford F-150 with 2 Wheel Drive
- Video: Review of CURT Front Receiver Hitch - Custom Fit Front Mount 2 Inch Receiver - 31026
- Video: Derale Series 9000 Plate-Fin Transmission Cooler Kit w/ NPT Inlets Spec Review
- Video: Review of Weigh Safe Tongue Weighing Fixed Height Ball Mount - WS56KR
- Video: Trailer Brake Controller Installation - 2002 Ford F350
- Q&A: Should Trailer Be Exactly Level When Being Towed?
- Q&A: Can a Trailer Ride With the Tongue at an Upward or Downward Angle
- Video: Feature Breakdown: Universal Installation Kit for Trailer Brake Controller
- Shop: Trailer Wiring