Does Valterra Spigot to Spigot Valve part # T1001A Fit Into or Over 1-1/2 inch Pipe
Updated 04/30/2018 | Published 04/28/2018
Question:
Is the T1001A Valterra valve 1-1/2inch inside diameter or outside diameter?
asked by: Emery S
0
Expert Reply:
Since the Valterra valve part # T1001A is a "spigot to spigot" that means that it's designed to have 1-1/2 pipe fit "over" both sides. That means the outside diameter is 1-1/2 inch. The opposite of spigot is hub. Hubs fit over spigots.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Waste Valve for RV Gray Water Tank - 1-1/2" Diameter - Spigot to Spigot
- RV Waste Valve
- Straight Valve
- Single Waste Valve
- 1-1/2 Inch Valve Body
- Manual
- 1-1/2 Inch Hub
- 1-1/2 Inch Spigot
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Recommended Class IV Hitch for a 2012 Chevrolet Silverado 1500
- Q&A: Spray Attachment for Dometic 400 Series
- Q&A: Which Vitrifrigo Fridges have R600a Comperssors
- Q&A: Replacement for Kaper II 1A-S-20 Trailer Lights
- Q&A: Looking For A Replacement Circuit Board For My MaxxAir Fan Part 10B24275N
- Q&A: Does the Valtera Heel Inlet with 3" Elbow have a Hub or a Lug Fitting?
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide