What Size Fastener Fits License Plate Light LP31CB
Updated 04/19/2018 | Published 04/18/2018
Products Featured in This Question
Question:
Hi, I was wondering what size of fasteners are required for the LP31CB lights. Do you have any license plate lights that use #10 and have the ground built in, so no extra lead for the ground?
asked by: Austin
Expert Reply:
At most you would use 1/4 inch screws with license plate light # LP31CB. A 10mm would be too large. Generally speaking 1/4 inch is about as large as you can go on most license plate lights.
We have # LP81BB which does have a separate ground wire though you could ground it right at the mounting hole using the screw used to mount the light (either side).
Product Page this Question was Asked From
Optronics Mini Trailer License Plate Light - Chrome Plated - Incandescent - Rectangle - Clear Lens
- Trailer Lights
- License Plate Lights
- License Plate
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 2-9/16L x 1-1/4W Inch
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Identifying Curt Hitch on 2017 Subaru Crosstrek
- Q&A: Best Flat Towing Setup for a 2025 Ford Maverick Hybrid
- Q&A: What Size Socket is Needed for DeeMaxx Trailer Wheel Lug Nut
- Q&A: How Long is the DeeMaxx Trailer Wheel Lug Nut
- Q&A: Trailer Jack Replacement for Shelby 5862A
- Q&A: How Long Should My Safety Chains Be?
- Q&A: How To Measure For Correct Safety Chain Length For Trailer
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Tell the Weight Rating of a Trailer Axle