Recommended Torque When Installing 7 Inch AxleTek Brake Assemblies
Updated 04/17/2018 | Published 04/14/2018
Question:
What are the torque specs on the studs?
asked by: David D
0
Expert Reply:
When installing the Electric Trailer Brake Kit - 7" - Left and Right Hand Assemblies # AKEBRK-2 you will want to torque them to 30-50 ft lbs. If you don't have a torque wrench, if you tighten the nut until the lock washers flatten out, you will likely be within that range.
expert reply by:
Jason S
0
Product Page this Question was Asked From
etrailer Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Manual Adjust
- 7 x 1-1/4 Inch Drum
- 2000 lbs Axle
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Roof Rack
- Shop: Brake Controller
- Video: Breaking Down the etrailer Electric Trailer Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Shop: etrailer Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs
- Shop: Yakima LockNLoad Platform Roof Tray - Aluminum - 76" Long x 54" Wide
- Shop: Trailer Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: 7-Way Molded Trailer Wire Connector, 6' Long: The Breakdown
- Video: An In-Depth Look at the etrailer Electric Trailer Brakes
- Q&A: What Info Is Needed to Pick Out Replacement Axle for '82 Burro Trailer
- Q&A: Troubleshooting 12 Volt Power Circuit not Functioning on 7-Way After Re-Wire
- Q&A: Troubleshooting Prodigy RF Brake Controller Installation in 2017 Mercedes-Benz GLE-Class
- Q&A: 7-Way Extension for Towing Food Truck with 2003 Ford Expedition
- Shop: Trailer Wiring
- Search Results: yakima molle panels
- Search Results: roof platform
- Search Results: locknload
- Search Results: thule caprock
- Search Results: curt 7 pin
- Shop: Crossbar Clamps for Yakima LockNLoad Platform Rack - Qty 2
- Shop: Rhino-Rack Locking Endcaps for Vortex Aero Crossbars - Metal Cores - Qty 4
- Shop: Replacement Vortex Strip for Rhino-Rack Vortex Aero Crossbars - 15-3/4" Long - Qty 1
- Shop: Yakima LockNLoad Platform Rack for Crossbars - Aluminum - 60" Long x 54" Wide
- Shop: Cordless Circuit Tester
- Search Results: 6 pin square connector
- Search Results: seal puller
- Video: Dexter Trailer Hub and Drum Assembly for 2,200-lb E-Z Lube Axles Feature Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams