Can the Fulton XLT # F141132 be Used as Replacement Jack on a Centurion Boat Trailer
Updated 06/10/2026 | Published 04/13/2018
Question:
Is this a direct replacement for my Centurion boat trailer jack?! Fulton F141132
asked by: Justin
1
Helpful Expert Reply:
I can't see any part numbers or manufacturer names from your picture, but the Fulton XLT # F141132 does look very similar.
I went out to the warehouse and measured the bracket that the bolt, washer, and nut go through for the installation. The wider inside measured about 1-5/8" while the outside hole measured 3/4" as you can see in the attached photo.
expert reply by:
Jon G
1
click to enlarge
click to enlarge
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trailer jack
- Search Results: fulton trailer jacks
- Search Results: f2 jack
- Shop: Trailer Valet Boat Jack w/ Wheel - Sidewind - Swivel - 10" Lift - 1,000 lbs
- Q&A: Replacement Jack For A 2003 Ranger Trailer Boat Trailer
- Shop: Dutton-Lainson Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 12" Lift - 1,000 lbs
- Q&A: Upgrade to Replace Fulton Boat Trailer Jack FTJ120W0301
- Video: Complete Breakdown of the Fulton Boat Trailer Jack w/ Wheel
- Shop: Gustafson 12V RV Porch Light - 12" Long x 5" Wide - Black
- Q&A: Replacement Trailer Jack for Fulton Jack that Uses Snap Ring
- Q&A: Replacement Mount to Install Fulton Trailer Jack # TJ120W0301 on Opposite Side of Trailer
- Search Results: 225 75r15
- Shop: MB Sturgis Propane Pigtail w/ Back Check - Type 1 x 1/4" Male Inverted Flare - 20"
- Search Results: scare light
- Shop: Round Snap Ring Swivel Trailer Jack w/ Footplate - Topwind - 15-1/4" Lift - 2,000 lbs - Weld
- Search Results: levels
- Shop: etrailer Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 11" Lift - 1,500 lbs
- Search Results: 141132
- Shop: B&B Nautilus P1 RV Water Control Panel - 16-1/2" Tall x 11-1/2" Wide - Polar White
- Q&A: Replacement Jack that Fits the Weld On Mounting Bracket for Fulton F2 Jacks
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Snap Ring Hole Size of Fulton Swivel Jack and Compatibility with Shelby Model 5756 Welded Plate
- Shop: Brake Controller
- Shop: RV Interior Lighting
- Shop: Trailer Wiring
Steve
6/10/2026
I know this is old, but I just recently installed a XLT on my older magnum series welded pivot, and the bolt and bushing system are exactly the same. Bolted right on to my trailer's existing bracket and bolt.