Does Alternator Amperage Need to be Regulated for Charging Batteries on Trailer
Updated 04/03/2018 | Published 03/31/2018
Question:
Im installing a dual battery system in my truck with a deep cycle that will power radios, winch, lights, etc. I have a battery isolator, but is there a product that will limit or regulate the amperage from the alternator to properly charge the deep cycle battery?
asked by: Jeffrey M
0
Expert Reply:
Voltage regulators are the mechanisms that alternators use to prevent over charging a vehicle battery. Since your truck alternator already has that you would not need to regulate that amperage again for your trailer battery. Your isolators and batteries would be fine as-is.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Brake Controller Installation: Starting from Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Troubleshooting A Thomas Payne Recliner That Will Not Recline
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)