How Many V-Wing Brackets Are Needed To Support A 28-ft Long Pontoon Boat
Updated 03/29/2018 | Published 03/28/2018
Products Featured in This Question
Question:
How many of these brackets would I need to support a 28 foot pontoon boat?
asked by: Scott C
0
Expert Reply:
I contacted the manufacturer and one V-Wing Bolster Bracket, Item # CE26244G, should be placed at each frame cross member.
Mounting hardware for these brackets is not included so I recommend using a screw and washer like our 3/8 Inch Stainless Steel Hex Lag Screw, Item # FA74521, and Stainless Steel Washer, Item # FA0152661.
I have attached a video for you to check out.
expert reply by:
Brint H
0
Product Page this Question was Asked From
CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers - Galvanized Steel - Qty 1
- Boat Trailer Parts
- Bunks
- Bunk Bracket
- 6 Inch Tall
- 3 Inch Wide
- Galvanized Steel
- 15-1/2 Inch Long
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Know Which Master Cylinder Will Be The Correct Replacement For A Surge Actuator
- Q&A: How To Install Rollers On a Pontoon Boat
- Q&A: How Many Screws Are Included With The Stainless Steel Hex Lag Screw # FA74521?
- Q&A: Are All 3,500 lb Axle Hub/Drums Interchangeable
- Q&A: Would 7-Way Trailer Wiring Circuit Have Amperage Rating for Powering 13 amp Horn
- Q&A: Solution for Transporting Native Titan 10.5 Kayak
- Q&A: How To Replace 18 Foot Long Bunk Boards On a Pontoon Boat Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: What To Look For When Buying Ratchet Straps