Compatibility of the Stake Pocket Tie-Down Anchor Part # WFSPDR
Updated 03/16/2018 | Published 03/15/2018
Products Featured in This Question
Question:
The stake pockets on my car hauler measure 5x1.75inch inside. Im certain these will work but would like your opinion.
asked by: Tyler
Expert Reply:
The Stake Pocket Tie-Down Anchor part # WFSPDR is designed to fit in a standard 2x4 stake pocket opening which actually measures to be around 3-1/2" long x 1-1/2" wide inside to inside. If the "5x1.75inch" you provided is formatted length x width then this tie-down would not be a good fit for you and I recommend adding part # C83072 in order to accommodate it.
I have attached a review video of the above tie-down for you. The dimensions for the tie-down can be found on the product page.
Product Page this Question was Asked From
Stake Pocket Tie-Down Anchor - Black Powder Coat - 2-1/4" D-Ring - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Stake Pocket
- Powder Coated Steel
- 4000 lbs
- Drop-In
- Folding
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can Furrion Vision S+ Be Used As Rear View Mirror
- Q&A: Is There a Version of the Andersen Weight Distribution System that Has 2-5/16 inch Ball
- Article: Trailer Hitch Installation Tips
- Q&A: How Much Do the Power Mountain Tallboy Off-Road Bottle Jacks Weigh?
- Q&A: Recommended Hydraulic Trailer Jack to Work w/a Existing Hydraulic Pump System
- Q&A: How Do The Mounting Holes On The Demco Coupler DM14040-81 Measure?
- Q&A: Can Door Be Replaced On Mighty Cord Replacement RV Power Inlet
- Q&A: How To Test A Lippert Hydraulic Slide/Leveling System Solenoid And Motor
- Article: Spring Towing Readiness Checklist
- Article: Types of Bumpers
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Install E-Track in 3 Easy Steps