How do Rear Slipper Spring Hangers Attach to Trailer Frame
Published 03/07/2018
Question:
How are the rear hangers for slipper springs mounted to the trailer frame?
asked by: Jim
0
Expert Reply:
Rear slipper spring hangers like the # 30-6-1 are typically welded to a trailer frame.
I attached a help article on slipper springs for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Rear Hanger for 2" Wide Slipper Springs - 6-3/8" Tall - 5/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- 5/16 Inch Diameter
- 6-3/8 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Brake Controller Wiring Harness on 2026 Ford F-250 WT
- Q&A: Can You Replace 11 Inch Equalizer For Slipper Springs With 12 Inch Equalizer
- Q&A: Whats The Minimum Bed Rail Clearance Needed For A Gooseneck/5TH Wheel Trailer with a 2021 Ram 3500?
- Q&A: What Is Difference Between Bargman 7-Way Connectors 54006-009 and 54006-057
- Q&A: Can Curt Tow Bar be Used with Blue Ox Base Plate Kit
- Q&A: Correct D-Washer for Spindle That measures 1.06" Where the Bearings Sit
- Q&A: Replacement 6-Leaf, 7,000LB Double Eye Spring For a 2012 Dutchman Voltage 3950 Toy Hauler
- Article: Trailer Maintenance Schedule
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure a Trailer Axle
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?