Wiring Derale Atomic-Cool Remote Transmission Cooler Kit D15950 for Pusher Application
Updated 03/05/2018 | Published 03/03/2018 >
Products Featured in This Question
Question:
To revers fan flow is it as simple as connecting the ground wire to the blue wire and connecting the 12v power to the black wire?
asked by: Brandon
Expert Reply:
To reverse the polarity and airflow direction of the Derale Atomic Cool transmission cooler # D15950 from a puller to a pusher installation you will need only reverse the two wires to the fan motor. This process is covered in the instructions for fan part # D16508 which are linked for you.
Do note that puller applications will usually be much more efficient since they allow the fan motor to work in the same direction as the passive airflow. But my contact at Derale did confirm that nothing more than polarity reversal is required.
Product Page this Question was Asked From
Derale Atomic-Cool Remote Transmission Cooler Kit w/ Fan, -8 AN Inlets - Class V
- Transmission Coolers
- Remote Cooler
- Heavy-Duty Truck
- Remote Mount
- 12-3/4W x 9-3/8T x 4-5/16D Inch
- With - 8 AN Inlets
- Derale
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Cushioned Equalizer Replacement Options For Factory Equalizer 6" Wide and 4" Tall
- Q&A: Recommended Replacement Equalizers, Bolts, Bushings And Shackle Straps For Tandem Axle Horse Trailer
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Q&A: Will A Transmission Cooler Reduce Airflow To My Radiator?
- Q&A: Transmission Cooler Installation Tips for a 1994 Mercury Grand Marquis LS
- Q&A: Difference Between Derale Series 8000 Transmission Cooler # D13503 and # D13502
- Q&A: Installation of Transmission Cooler and Thermostat on 2013 Toyota Sienna XLE 3.5L V6
- Article: Frequently Asked Questions About Transmission Coolers

