Best Trailer Hitch for 2013 Buick Verano  

Question:

Expert Reply:

If you do not have the Turbo and Dual Exhaust models I would go with the Curt Trailer Hitch Receiver # C11282 mainly because according to our website the install difficulty is easier on this one than the Curt Trailer Hitch Receiver # C11282. They both have the receiver opening of 1-1/4" x 1-1/4" and the weight rating of 200lbs TW and 2000lbs GTW. You will also need the Draw-Tite Drawbar for 1-1/4" Hitches # 3593 rated at 2000lbs and the Pin and Clip # PC2. If you are looking for a hitch ball, the 2" Hitch Ball # 19258 the best choice.

You will also need the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C56288. It quickly and easily installs a 4-way trailer connector on your Buick Verano with this custom harness. T-connector plugs directly into existing wiring.

This custom-fit T-connector plugs into your Buick Verano's wiring harness, which is located behind the driver's-side and passenger's-side tail lights. You will have to remove the trunk floor coverings and rear scuff panel, and pull back on the trunk liner to access these connection points. Once you've plugged in the T-connector, run the hot lead up to your car battery. Connect the lead to the included fuse holder, and then connect the fuse holder to the positive terminal on your battery.

expert reply by: Timothy G

0