Where is the Driver Side Kick Panel Located on a 2011 Toyota Tacoma for Power Tailgate Lock Install
Updated 07/07/2011 | Published 07/06/2011
Question:
Im installing a tail-gate lock, and I cant find the kick-panel and the access panel I have a 2011 Toyota-Tacoma-extended cab. I have successfully installed the actuator and short wire harness and ready to install the long wire harnesss and attach to the switch in the driver side door. HELP!!!!!!aNY SUGGESTIONS???
asked by: Doc E
Expert Reply:
The kick panel is that trim piece located to the left of the emergency brake pedal, a little forward, and to the right of where the door hinges (if sitting in the driver seat). Different vehicles have this panel attached in different ways so I am not certain what tool or tools you will need to remove it.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is There a 4-Way Wiring Harness for a 2026 Chevy Equinox Activ?
- Q&A: Parts Needed to Add a Brake Controller to a 2024 Nissan Frontier Without Tow Package
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Why Does The Negative Battery Cable Need To Be Removed To Flat Tow A 2021 Chevy Spark Manual
- Q&A: Will the Brake Buddy Battery Maintainer work with Battery Disconnect RM-766
- Q&A: How To Determine What Correct Propane Pigtail Is Needed
- Q&A: 2015 Toyota Tacoma Tailgate Lock Recommendation for 2015 Toyota Tacoma with Back Up Camera
- Q&A: Flat Towing Set Up for a 2024 Chevy Trax RS-2