Can Power Grip RV Power Cord Adapter # CAM55175 be Used with a Welding Machine
Published 01/25/2018
Question:
Can this be used with a welding machine if everything matches?
asked by: Rod
0
Expert Reply:
If your welding machine takes the standard 30 amp travel trailer type plug with the pins in the same configuration AND it operates on 125 volt power but does not draw more than 15 amps then you could use the Power Grip RV Power Cord Adapter # CAM55175.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Camco Power Grip RV Power Cord Adapter w/ Handles - 125V - 30 Amp Female to 50 Amp Male
- RV Plug Adapters
- Adapter Cord
- 30 Amp to 50 Amp
- RV Cord to Power Hookup
- 50 Amp Male Plug
- 30 Amp Female Plug
- Angled Plug
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Gooseneck Hitch for 2026 Ram 3500 Big Horn Short Bed
- Q&A: Can Watchdog Power Center Surge Protector Be Used On Both 30A AND 50A RV?
- Q&A: Availability of Rain Cover for Hughes Power Watchdog
- Q&A: Best Rear Suspension Enhancement For 2020 Ram 2500 4WD With In-Bed Gooseneck Hitch
- Q&A: Is There an Aftermarket 5th Wheel Prep Package for a 2026 Ram 2500?
- Q&A: How Much Does The Watchdog Surge Protector 30A HU84ZR Weigh?
- Q&A: Does Tandem Axle Trailer Need Two Sets of Andersen Camper Levelers
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Best Bike Racks for Electric Bikes
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Camping Tips for First-Time RVers
- Article: 7 Common Questions Everyone Has About Trailer Tires