Can CE Smith V-Wing Bolster Bracket be Used on Boat Lift
Published 01/19/2018
Question:
you have a pontoon cradle that fits a boat trailer Item # CE26244G but I want to install cradles on my boat lift which consists of a forward and rear galvanized I-beams. The I-beam is 3 1/4 wide and 5inch tall. Do you have a product you recommend to support my new tritoon. I suspect whatever it is will be six cradles.
asked by: Jeff
Expert Reply:
The CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers # CE26244G referenced in your question is designed for boat trailers but can be used on your boat lift. You will just need to supply the 6 inch or 8 inch wide bunk boards for use with these brackets.
These bolster brackets are designed specifically to support pontoon boat trailer bunks. They measure 15-1/2 inches long, 3 inches wide, and 6 inches tall. I have attached a short video demonstration on this product that you can also check out.
Product Page this Question was Asked From
CE Smith V-Wing Bolster Bracket for Pontoon Boat Trailers - Galvanized Steel - Qty 1
- Boat Trailer Parts
- Bunks
- Bunk Bracket
- 6 Inch Tall
- 3 Inch Wide
- Galvanized Steel
- 15-1/2 Inch Long
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How To Know Which Master Cylinder Will Be The Correct Replacement For A Surge Actuator
- Q&A: How To Install Rollers On a Pontoon Boat
- Q&A: How Many Screws Are Included With The Stainless Steel Hex Lag Screw # FA74521?
- Q&A: Would 7-Way Trailer Wiring Circuit Have Amperage Rating for Powering 13 amp Horn
- Q&A: Solution for Transporting Native Titan 10.5 Kayak
- Q&A: Are All 3,500 lb Axle Hub/Drums Interchangeable
- Q&A: How To Replace 18 Foot Long Bunk Boards On a Pontoon Boat Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: What To Look For When Buying Ratchet Straps