How to Determine Spindle Size for a 2004 Triton Elite WCII PWC Trailer
Updated 06/17/2011 | Published 06/16/2011
Question:
Im looking to find out what spindle I need to replace the chewed up spindle on my 2004 Triton elite WCII jetski trailer? Also how do you go about replacing the spindle? Thanks,
asked by: Glen
Expert Reply:
There are two ways to determine what spindle you have on your 2004 Triton Elite WCII Jet-Ski trailer.
The first way is to look at the number that is stamped on the bearings that you removed when you took the hub off.
The second way is to use a dial caliper and get the measurements and find the spindle that matches those measurements.
The new spindle must be absolutely square with the axle in order to prevent tire wear and wheel tracking problems. I would recommend finding a welder who is experienced with trailer axles. Your local RV dealer or repair facility could probably refer you.
Product Page this Question was Asked From
Square #84 Spindle for 3,500-lb Trailer Axles - 1-1/2" Wide
- Trailer Spindles
- Standard Spindle
- Without Flange
- L68149
- 1-1/2 Inch Diameter
- Square
- For 3500 lb Axle
- TruRyde
more information >
Continue Researching
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Will a Dexter Trailer Hub Fit on a Lippert Trailer Axle
- Q&A: Backup Camera that Will Plug In Line with a 7-Way Trailer Connector on a 2005 Toyota Tundra
- Q&A: Availability Of Trailer Hub With .75" Outer And 1.25" Inner Bearings
- Q&A: Recommended Replacement for Atwood G6A-7 Water Heater
- Q&A: What Size Axle Does a #84 Spindle Fit
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Q&A: What is the Correct Race for Use with Bearing # L68149?
- Q&A: Difference Between 205/75-15 Kenda Tires with Black Mod Wheel
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: How to Determine Tire/Wheel Diameter
- Article: Slipper Spring Trailer Suspension System Review
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer