No Lights On Trailer When Using Curt Custom Wiring # C56161 On 2010 Honda Odyssey
Updated 06/21/2011 | Published 06/15/2011 >
Products Featured in This Question
Question:
I have a 2010 Honda Odyssey. I checked the trailer with a circuit tester and a external battery and the trailer lights work fine and have a good ground. When I connect the trailer to the van I have no lights at all on the trailer. When I connect a voltage meter to the trailer ground connector in the van and probe the wires all three wires have 12.5 volts coming out of them with the van not running and the ign. switch off. Is this normal. I connected the male and female plugs together van to trailer and probed in between them and the voltage goes to zero while connected.
asked by: Dick O
Expert Reply:
You will want to check the converter of the Curt Custom Wiring, part # C56161. Use a circuit tester, like part # PTW2993 to check to make sure there is power going into the converter. Then check to see if you are getting power coming out of the converter. If you are not getting power coming out of the converter, it may need to be replaced.
Also, I would check the vehicle side connector to make sure there is not any corrosion in the connector which could be causing a bad connection.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Comparing Curt and Draw-Tite Trailer Hitches for a 2015 Honda Odyssey
- Q&A: What is Needed to Add Trailer Hitch to 2009 Honda Odyssey
- Q&A: What are Differences Between Curt and Tekonsha Harnesses?
- Article: Trailer Hitch Installation Tips
- Article: Anti-Rattle Devices
- Q&A: Towing Package for a 2008 Honda Odyssey
- Q&A: Will The Peterson M540 Light Kit Fit A Bracket With 2-1/4" of Head Room?
- Q&A: Can Aftermarket Brake Controller Install in 2021 Ram with Integrated Controller
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Can Weight Distribution System Be Used on Aluminum Trailer Frame
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Dexter Service Bulletin #014
- Article: How to Choose the Right Trailer Hitch Class


