Inner and Outer Diameter of Fittings on Valterra Bladex Waste Valve # T1002A
Published 12/11/2017
Question:
Is it Schedule 40 size or class 200?
asked by: Floyd
0
Expert Reply:
The two things you mentioned refer to the wall thickness of PVC. So to answer that question the # T1002A that you referenced has an inner diameter of 2 inches and an outer diameter of 2-3/8 inches on both sides.
For more info check out the review video I attached for this as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve for RV Holding Tank - 2" Diameter - Spigot to Spigot
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 2 Inch Valve Body
- Manual
- 2 Inch Spigot
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Can Furrion Chill Cube RV Air Conditioner Be Installed On A Bus Or Sprinter Van?
- Q&A: Replacement Screen Frame and Interior Trim for a VD0433 Roof Vent
- Article: Trailer Lighting Requirements
- Q&A: Recommended Replacement For A Fan-Tastic Vent Model 6504-414
- Q&A: Replacement Lens for a Bargman 84 Series Trailer Tail Light
- Q&A: Replacement for Peterson 134-15 Series Clearance Lights
- Q&A: Do You Have a Replacement Thermostat 15034 For an Atwood Furnace?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: How to Measure for Motorhome Steps
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer