Is Fascia Trimming Required When Installing Hitch on 2013 Ford Edge Sport
Published 11/29/2017
Question:
I see your post stating you have a hitch for the sport. What happens with the rear bumper cover ? The sports is much lower then a reg edge ? Does it hang lower then the cover or does the cover need to have a hole cut in it ?
asked by: Steven J
0
Expert Reply:
When installing a trailer hitch on a 2013 Ford Edge like the Curt part # C13067 the lower fascia does need to be trimmed as the fascia is different like you said. If you check out the picture I attached you'll see exactly how this is done.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Difference Between Curt and etrailer Hitch for 2024 Honda CR-V Hybrid
- Q&A: Trailer Hitch and Wiring Recommendation for 2014 Lincoln MKX AWD
- Q&A: Recommended Brake Controller for a 2023 BMW X5 w/a Stealth Hitch Wiring Harness
- Q&A: Choosing OEM or Aftermarket 5th Wheel Puck System for 2021 Ford F-250
- Q&A: Difference Between Timbren TABSFR150RB and TFR150RB For 2018 Ford F-150 Raptor
- Q&A: Which Draw-Tite Trailer Hitch Receiver Fits a 2013 Ford Edge SEL with Dual Exhaust
- Q&A: Inexpensive Trailer Hitch and Wiring Recommendations for a 2009 Ford Edge AWD to Tow a Boat Trailer
- Article: How to Change a Trailer Tire
- Article: How to Choose the Right Trailer Hitch Class
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Trailer Hitch Installation Tips
- Article: Can You Flat Tow a Ford Escape?
- Article: How to Choose a High-Low Adapter
- Article: How to Measure for Trailer Hitch Drop