Solution to Reduce Voltage When Vehicle Is Turned On for Brake Light Switch Circuit
Updated 11/28/2017 | Published 11/27/2017
Products Featured in This Question
Question:
Hi installed a REDARC Tow-Pro elite and have wired the brake trigger into my switch when the vehicle is off its 00.0 apply brake 12.5 but when it’s started or the vehicle is switched on its 00.1 apply brake 12.5 how do I fix it so it’s 0.00 so my brakes disengaged
asked by: Beau
0
Expert Reply:
What you can do is install a diode like part # RM-690 on the stoplight circuit which would stop the .1 of a volt from telling your brake controller it should be looking for deceleration.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Splice-In
- Dash-Mounted Knob
- Behind-Dash
- Up to 3 Axles
- Indicator Lights
- Single Trailer Only
- Redarc
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Recommended 7-Way Connector for a 2025 Toyota Grand Highlander
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Recommend Smallest Trailer Brake Controller For a 2014 Jeep Wrangler Unlimited W/ Factory Tow PKG
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Which Wireless Trailer Brake Controller Is Best
- Q&A: Replacement 6,000 lbs Trunnion Spring Bars for Equalizer and Fastway e2 Weight Distribution Systems
- Q&A: How to Install a 7-Way and Brake Controller on a 2009 Subaru Tribeca