Mounting Bolt Pattern for the Valterra Bladex Waste Valve Body
Updated 10/10/2017 | Published 10/09/2017
Question:
I want to be sure this 1 1/2 valve will replace the Valterra valve on my 1990 Terry camper. My old part has a 2 7/16inch bolt pattern and want to be sure this new part has the same bolt pattern for the four holes. Can you confirm please.
asked by: Steve
0
Expert Reply:
Sounds like the part # T1001VP would fit as a replacement but you might want to remeasure. This valve has mounting holes that are 2-1/2 inches square.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve Body for RV Gray Water Tank - Plastic Handle - 1-1/2" Diameter
- RV Waste Valve
- Straight Valve
- Single Waste Valve
- 1-1/2 Inch Valve Body
- Manual
- 1-1/2 Inch Spigot
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Q&A: Recommended Class IV Hitch for a 2012 Chevrolet Silverado 1500
- Q&A: Can I Use the etrailer Awning Fabric on a Solera Awning
- Q&A: How Do I Adapt a 1-1/2" Gray Water Valve to a 3" Bayonet Sewer Connection?
- Q&A: Replacement Grease Cap Plug for EZ Lube Grease Cap
- Q&A: Recommended LCD Single Zone Thermostat for Dometic RV Air Conditioners
- Q&A: Replacement Roof Vent Lid for Dexter Roof Vent Serial Number VE0108
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Does Solar Panel Type Really Matter?
- Article: Converting Your RV Water Heater to Tankless
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How Much Solar Power Do I Need For My RV?