Does Power Wire for Peterson 138A Clearance Light Connect to Ground of Other Clearance Light
Updated 10/10/2017 | Published 10/09/2017 >
Question:
I have the hot wire and understand that that is connected to the wire included with the light. However, there is a second wire that goes to the next light. How do I connect that... where? These lights are in series, right?
asked by: Theresa F
0
Expert Reply:
You'd need to run your other lights power wire to the same power source as what the # 425600 will connect to. These are not wire like Christmas lights where the power of one light is the ground of the next.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Peterson Double Bullseye Clearance and Side Marker Trailer Light - 2 Bulbs - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 2W Inch
- Amber
- Peterson
more information >
Continue Researching
- Q&A: Using A Marker Light With Two Wires To Replace Old Light That Only Had One Wire
- Article: Trailer Lighting Requirements
- Q&A: Replacement Threaded Grease Cap for 1.98" Hub Bore
- Q&A: Replacement 3/4-Inch Black RV Vinyl Trim
- Q&A: Replacing Titan Aero 6000 with Dexter Surge Actuator 099-175-20
- Q&A: Can the Titan Aero 6000 Surge Brake Actuator Be Repaired Or Should It Just Be Replaced
- Q&A: Best Replacement Actuator for a Titan Aero-6000
- Q&A: Replacement Reservoir Tank for Lippert Hydraulic Power Slide Out Unit
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Double-Eye Trailer Suspension System Review

