How Much of the Pin Sticks Out in the Locked Position on Bolt-On Zinc Spring Latch Item # SL716
Updated 09/21/2017 | Published 09/20/2017
Question:
When pin is closed there by locking the gate in place what is the length of the pin from the bracket to the end. The straight end length, not the looped end that you pull on. I need to make sure this pin will reach the hole for the pin on the gate when this is mounted. Thank you in advance!
asked by: Jay
0
Expert Reply:
For the Bolt-On Zinc Spring Latch Item # SL716 the distance from the bracket to the end of the pin (when in the locked position) is approximately 1-1/8 inches.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Overall Dimensions of MORryde Sliding Tra for RV Cargo Compartment # MR84FR
- Q&A: Trailer Brake Controller Connector Location for 2018 Toyota Tundra
- Q&A: Is There a Weight Capacity on CE Smith Fold-Up Wheel Chocks
- Q&A: Is the Enclosed Trailer Transition Plate Diamond Plate?
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Will the Demco 5-Position Adjustable Channel Bracket Fit a Boat Trailer
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Distance Between The Mounting Tabs On A The Roadmaster Direct-Connect Base Plate Kit # 1437-3
- Article: Trailer Lighting Requirements
- Article: Rooftop Cargo Carriers
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Article: Adding Electric Over Hydraulic Disc Brakes