Length of Paneloc Spring Latch Handle
Updated 09/05/2017 | Published 09/02/2017
Question:
What is the measurement of the latch handle from curve to end of the handle
asked by: David R
0
Expert Reply:
The pin handle of the Paneloc Heavy Duty Spring Latch # F779-204U234 is roughly 2", and the overall length of the pin is 5-7/8".
I've attached a link to a review video for you to check out as well.
expert reply by:
Kyle S
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Spring Latch w/ Cover and Holdback - 4 Hole - 2-7/8" x 2" - Stainless Steel
- Trailer Door Latch
- Right Hand
- Spring Latch
- Non-Locking
- Bolt-On
- Stainless Steel
- Paneloc
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Availability Of Replacement Brushes For CargoSmart Boot Cleaning Brush 3481733
- Q&A: Diagram Showing How Trailer Brakes are Wired
- Q&A: Replacement Idler Hub for Hub Stamped With TMW 46210 1209
- Q&A: Replacement Hub, Bearings, Races, and Seals for Trailer Hub with H-1377 Bearing
- Q&A: How To Determine Weight Capacity of Trailer Torsion Axle
- Q&A: Replacement Grease Seal for Dexter 63052
- Q&A: Availability of Right Hand Buyers Products Spring Latch
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Determining Trailer Tongue Weight