Length of Exposed Part of Pin when Pulled All the Way Out on Bolt-On Zinc Spring Latch # SL716
Updated 08/30/2017 | Published 08/29/2017
Question:
When the pin is fully extended out how long is it? Not the distance covered with the spring, only the distance outside the bracket.
asked by: Watson L
0
Expert Reply:
I went out to the warehouse to measure the Bolt-On Zinc Spring Latch Item # SL716 for you. With the pin pulled all the way out (spring fully compressed) it measures approximately 4-7/8 inches from the outside of the bracket to the end of the loop. When resting in the open position that measurement is 3-3/8 inches.
expert reply by:
Michael H
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
- Trailer Door Latch
- Latches
- Spring Latch
- Steel
- Non-Locking
- 7/16 Inch Pin Diameter
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Ultimate Overview of the Bolt-On Zinc Spring Latch
- Shop: Bolt-On Zinc Spring Latch
- Search Results: gate latch pin
- Q&A: Dimension of Redline Bolt-On Spring Latch # SL716
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: What Valve Stem For Aluminum AM03 Series Black Machined Trailer Wheel AM43NR
- Q&A: Will The Curt 7-Way/4-Way Connector 57015 # C42JR Allow For Both Connectors To Be Used When Towing?
- Q&A: Dust Cap Recommendation for Ranger Trail Boat Trailer 9606087
- Q&A: Can Two Speed Gearbox Be Installed On Single Speed Ram 1200 Series 10K Jack
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Article: Trailer Lighting Requirements
- Article: Rooftop Cargo Carriers
- Article: How to Raise Your Travel Trailer Height
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer