What Size Hole is Needed to Mount Pollak Heavy-Duty Toggle Switch PK34213
Updated 08/08/2017 | Published 08/06/2017
Question:
What size hole should be drilled for the Pollak Heavy-Duty Toggle Switch - SPST- On-Off - 12 Volt - 50 Amp - 1.5inch Handle Item # PK34213
asked by: Dennis R
0
Expert Reply:
The threaded part of Pollak Heavy-Duty Toggle Switch - SPST- On-Off - 12 Volt - 50 Amp - 1.5" Handle Item # PK34213 has an outer diameter of 0.43 inches which is slightly less than 7/16. So a 7/16 inch diameter hole would work will since the switch will be held in the hole with the included nut.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Pollak Heavy-Duty Toggle Switch - SPST- On-Off - 12 Volt - 50 Amp - 1.5" Handle
- Accessories and Parts
- Wiring
- Switches
- Toggle Switch
- 50 Amp
- Pollak
more information >
Continue Researching
- Q&A: Replacement Spindle Washer For 3,500 Lb EZ Lube Spindle
- Q&A: Recommended Replacement Leaf Springs For Fifth Wheel Trailer
- Q&A: Replacing Wheels on a Trailer with 5 Spoke Utility Hubs and 8-14.5 Size Tires
- Q&A: Replacement Bearings, Races, Grease Seals & Brakes For Lippert 4,400LB Axle On Jayco Travel Trailer
- Q&A: Spare Tire & Wheel For 2023 Coleman Lantern 17B
- Q&A: Adding a Charge Line Circuit To a Trailer With a 4-Way/5-Way Flat Connector
- Q&A: Is a Spindle Washer Needed Between the Spindle Nut and Outer Bearing on Dexter 5 on 4-1/2 Hubs
- Article: Trailer Maintenance Schedule