Availability of Rear Slipper Spring Hanger for 1-3/4 inch Wide Spring  

Nope, the slipper spring rear hangers like the part #CE14017G do not require the use of a bushing between them and the spring. I attached a picture that shows how it will look when it is installed.

The mounting holes of the part #CE14017G and #CE140116G that you referenced are 7/16 inches in diameter. You would need to get bolts that would fit those hole sizes. Since applications can vary there isn't a set bolt size you would need.…

Basically you would need to replace the rear hanger with a double eye style hanger, use a shackle strap and then get the appropriate leaf spring. The lightest capacity spring we have is the part #e84SR which you referenced. For the price the best…

The best size match we have for a 2.035" hub bore is the Bearing Buddy Bearing Protectors part #BB2047 which measure 2.047". It's possible they will work but these trailer don't really use industry standard parts so…

My contact at CE Smith said that on their Trailer for Boats and PWCs #CE48810 the distance from the center of the ball coupler to the center of the axle is 120-inches. Overall length of the trailer, from front of coupler to rear of frame, is…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…