Using Pollack 6-Pin Connector for Lighting, Brake Monitoring, and Other Function when Flat Towing
Updated 07/17/2017 | Published 07/16/2017
Products Featured in This Question
Question:
I have a Roadtmaster 9700 and a motor home which already has a pollack 6 pin connector, cable and new connector with boot for the car side. I will be buying these three kits to connect up breaking, lights and monitor RM-98800, RM 155, RM-98850 will I be able to run all the wiring through the pollack 6 pin connector going to the motorhome and if so do you have diagram or instruction to explain.
asked by: Dale H
Expert Reply:
If you use the ground pin for all of the grounds from # RM-98850, # RM-98800, and # RM-155 then a 6-Way connector could handle the lighting, RV monitoring light, and one other function for a total of 6 functions (including the ground). The lights will use 3 pins, the grounds will use one, and the monitoring light will use 1 for a total of 5 functions leaving one function for something else.
There isn't a specific wiring diagram for this set up but I have included a picture that shows how a 6-Way connector is usually wired.
Product Page this Question was Asked From
Second Motorhome Braking Monitor/Alarm Kit for Roadmaster InvisiBrake Systems
- Accessories and Parts
- Flat Tow Brake System
- Second Vehicle Kit
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Second Vehicle Kit for Roadmaster 9700 Flat Tow Brake System
- Video: Setting up the Second Vehicle Kit for Roadmaster 9700 Flat Tow Brake System on a 2009 Ford Escape
- Video: A Closer Look at the Second Vehicle Kit for Roadmaster 9700 Flat Tow Brake System
- Shop: Vehicle Tow Bar Brake System
- Shop: Second Vehicle Kit for Roadmaster InvisiBrake Flat Tow Brake System
- Video: Install: BrakeBuddy Towed Vehicle Battery Charge Line Kit on a 2020 Jeep Gladiator
- Shop: Roadmaster Stop Light Switch Kit
- Video: Installation Guide for the Roadmaster Stop Light Switch Kit on a 2021 Jeep Wrangler Unlimited
- Shop: Replacement Braking Indicator Light for Roadmaster BrakeMaster Systems
- Article: Trailer Wiring Diagrams
- Shop: Second Motorhome Braking Monitor/Alarm Kit for Roadmaster InvisiBrake Systems
- Q&A: Wiring Brake Signal Wire to Combined Tow Light Harness on 2014 Honda CRV
- Q&A: Trailer Wiring Recommendation for 2019 Jeep Wrangler JL
- Shop: Second Vehicle Kit for Roadmaster BrakeMaster Flat Tow Brake Systems
- Shop: Second Vehicle Kit for Roadmaster Even Brake Systems with Serial Numbers below 27,496
- Video: Roadmaster Tail Light Wiring Kit with Bulbs: The Breakdown
- Search Results: roadmaster second vehicle kit
- Video: Review of Roadmaster Tow Bar Braking System Parts - Replacement Monitor Light - RM-300065-00
- Q&A: Can BrakeBuddy Charge Line Kit Install with Tow Vehicle that has Roadmaster Invisibrake
- Shop: Truck Bed Camera
- Video: Review of the BrakeBuddy Towed Vehicle Battery Charge Line Kit
- Search Results: brake light relay
- Search Results: rm~8700
- Search Results: brake light switch
- Q&A: Replacement Air Cylinder For Roadmaster InvisiBrake Flat Tow Brake System # RM-8700
- Q&A: Installation Instructions for Roadmaster Direct-Connect Base Plate Kit on 2021 Jeep Wrangler
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Q&A: 5th Wheel Hitch for Flatbed Diesel Pickup with Wood Deck
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: Brake Controller Installation: Starting from Scratch
on Accessories and Parts
