Installing The Replacement Upper Claw Base With Brass Nut For Yakima RailGrab Towers
Updated 07/17/2017 | Published 07/15/2017
Question:
Tried to replace this part but somehow can not figure out where the Brass nut goes in relation to the black claw tightener and the claw base
asked by: Kaycee T
0
Expert Reply:
On the Replacement Upper Claw Base with Brass Nut for Yakima RailGrab Roof Rack Towers - Qty 1 # Y8880279, the brass nut will go into a slot on the top of that assembly. I reached out to my contact at Yakima to confirm. I've attached a photo to help.
expert reply by:
Jason S
0
click to enlarge
Product Page this Question was Asked From
Replacement Upper Claw Base with Brass Nut for Yakima RailGrab Roof Rack Towers - Qty 1
- Accessories and Parts
- Roof Rack
- Tower Parts
- Claws
- Yakima
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Determine Which Yakima Railgrab Claw is Needed to Fit Vehicle
- Q&A: Front and Rear Hinges for a Yakima SkyBox 21 Cargo Box
- Q&A: All Replacement Parts for a Yakima Railgrab Tower
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: What Hitch For The 2026 Subaru Crosstrek Hybrid Has The Best Ground Clearance?
- Q&A: Replacement Claw Tightener for Yakima RailGrab Roof Rack Towers
- Q&A: Recommended Trailer Hitch and Towing Accessories for 2012 Kia Sportage SX
- Q&A: Curt Trailer Hitch vs. Draw-Tite Trailer Hitch on 2020 Ford Escape