CIPA Clamp-On Hotspot Bar Diameter Compatibility
Updated 07/17/2017 | Published 07/15/2017
Question:
What diameter of bar will this mirror clamp on?
asked by: KC S
0
Expert Reply:
The CIPA Clamp-On HotSpot Mirror - 4" x 8" - Convex # CM49504 is designed to fit on bars about 3/4 inch in diameter. There is adjustability so you can fit on bars slightly larger.
expert reply by:
Jason S
0
Product Page this Question was Asked From
CIPA Clamp-On HotSpot Mirror - 4" x 8" - Convex
- Blind Spot Mirror
- Convex
- Clamp-On
- Rectangle
- CIPA
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Measure for Offset on Trailer Wheel
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Hitch and Ground Clearance for a 2006 Toyota Matrix XRS and Curt Trailer Hitch # C12013
- Q&A: Choosing Between the CIPA and K-Source Universal Towing Mirrors for a 2008 Ford Expedition
- Q&A: Best Towing Mirrors for a 2016 Chevrolet Express Van
- Q&A: Recommended Towing Mirrors for a 2018 Chevy Express Van 3500
- Q&A: Where Should Fifth Wheel King Pin Sit in Relation to Axle Centerline on 2004 Ford F250
- Q&A: Proper Position of 5th Wheel King Pin In Relation to Rear Axle of Chevy Silverado
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide