Adjusting Latch of Demco Surge Coupler DM72VR to Fit Hitch Ball
Published 07/12/2017
Question:
I had purchased and installed the Demco Hydraulic Trailer Brake Actuator - Drum Brakes - Zinc Plated - 2inch Ball - 7,000 lbs Item # DM72VR. I have a 2 inch ball on my hitch but the actuator will not latch all the way on the top/ down. Is there a way to adjust this? is it dangerous to drive with it up thats what I have been doing. Thanks
asked by: Rick M
Expert Reply:
If you look under the coupler # DM72VR you will see what looks like a nut on the latch assembly with a spring behind it. I attached a picture that points it out.
Loosen it slightly until the ball fits in the coupler and latches properly.
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator - Drum - Zinc - 2" Ball - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 7000 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Demco
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement 10" Drum Hydraulic Trailer Brakes for Converting 3,500 lbs Axles to Hydraulic Brakes
- Q&A: New Brake Assemblies, Hub/Drums, Brake Lines, and Bearing Buddy for Trailer with 3,500 lb Axle
- Q&A: Replacement Actuator for an Older Atwood 85736
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Q&A: Replacement for a Tie Down Model 66 Drum Brake Actuator
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Trailer Wiring Diagrams
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Most Popular Wheel Bearings
- Article: What Size of Boat Trailer do I Need?