What are the Size of the Mounting Bolts for the Dexter Electric Trailer Brake Assembly # 23-434
Updated 07/10/2017 | Published 07/07/2017
Question:
What size are the four backer plate bolts
asked by: Kelly C
0
Expert Reply:
The mounting holes on the Dexter Electric Trailer Brake Assembly for 8K to 9K Axles, # 23-434, measures 1/2 inch in diameter.
These brake assembles will fit on mounting flanges that use 1/2 inch studs or bolts.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly - Self-Adjusting - 12-1/4" - Left Hand - 8K
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 8000 lbs
- Brake Assembly
- Self Adjust
- 12-1/4 x 3-3/8 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: How Much Does the B&W Companion OEM 5th Wheel Hitch # BWRVK3305 Weigh
- Q&A: Does Fifth Wheel Hitch Weight Count for Payload Capacity
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Soft Start Recommendation for 13K Bu Furrion Chill HE AC Unit
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: How to Determine What Generation of MORryde Steps You Have?
- Article: How to Charge a Dump Trailer Battery
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Lighting Requirements
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Is It Illegal to Leave My Hitch on My Truck?