Can the Replacement Ladder Support Peg # 8531-B Be Cut Down to 5 inches
Updated 07/06/2017 | Published 07/05/2017
Question:
Thor 2015 31S Thank you
asked by: Jim N
1
Helpful Expert Reply:
Yes, you could trim down the Replacement Ladder Support Peg # 8531-B to 5 inches. You would want to remove the cap at the end and cut it to length from that end (the end that attaches to the ladder). Then you could put the cap back on.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Replacement Standoff for Stromberg Carlson Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- Support Peg
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement Steps, Motor, and Control for Kwikee RV 27 Series Electric Steps
- Q&A: Looking For Black RV Ladder Standoff
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Exterior Ladder Replacement for 30ft 2017 Thor Motorhome
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Q&A: Replacement Gear for Kwikee Steps 9010000220 On Fleetwood Bounder Motorhome
- Q&A: Replacement Lippert Control Module for Kwikee Step 1510000140
- Q&A: Replacement Motor 1101422 for Kwikee Step Assembly