Can Edge CS2 Programmer be Unplugged from Vehicle Once Programming is Completed
Updated 06/26/2017 | Published 06/25/2017
Question:
I have a 2010 gmc sierra with the edge evolution cs2 on it. After i set the program in it that i want will it be safe to unplug the programmer ? And will the setting stay in the truck with it out?
asked by: Brian L
0
Expert Reply:
Yes, once the programming is complete with the Edge CS2 part # EP85350 that you have you can unplug it from the vehicle and it will run just fine and the tune stays on the vehicle. You only lose the monitor features when you do this.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Edge Gas Evolution CS2 Performance Tuner- Color Screen
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Increase Towing Power in 2003 Chevrolet Avalanche 1500 with 5.3L V8 Towing 7600-lb Trailer
- Article: Converting Your RV Water Heater to Tankless
- Article: Most Popular Wheel Bearings
- Q&A: How to Use Furnace With Furrion Chill Cube on 2017 Keystone Cougar 327RES
- Q&A: Replacement Motor for Fan-tastic 8100TR
- Q&A: Wiring Instructions For A Dometic RV Water Heater Single-Panel Control Switch
- Q&A: Horsepower Gains for 2014 Chevy Silverado 5.3L with Programmer, Cold Air Intake, and Exhaust Mods
- Q&A: Will Edge CTS3 Programmer Fit 2011 Chevy Silverado with 6.0 and Basic Bolt Ons
- Q&A: Edge Evolution Programmer for a 2015 Chevy Silverado 2500HD with 6.0 Liter Motor
- Article: Performance Chips and Modules
- Article: 5 Things to Know About Weight Distribution Hitches