How Is Handle For Cam-Action Lockable Door Latch Kit # 383200 Attached To Pipe
Updated 06/26/2017 | Published 06/24/2017
Question:
Does the pipe just compression fit to the cam lock? Do you just drive the cam lock into the 3/4inch ID pipe or is there a tack weld that needs to be done.
asked by: Steve
0
Expert Reply:
The handle of the Cam-Action Lockable Door Latch Kit # 383200 needs to be welded to a 3/4 inch pipe.
The rest of the hardware included with the kit can be bolted to the door. The pipe and the mounting hardware is not included.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Cam-Action Lockable Door Latch for Small Trailers and Trucks - Zinc Plated Steel
- Trailer Door Latch
- Reversible
- Cam-Action Latch
- Lock Not Included
- Bolt-On
- Zinc-Plated Steel
- Polar Hardware
more information >
Continue Researching
- Q&A: Does Advent Air RV AC Unit Use Wall Mounted Thermostat or Remote Thermostat
- Q&A: Recommended Handle Latch Kit for Barn Door on Dump Trailer
- Q&A: Can the A522VP Cam Locks Be Keyed Alike for a 2012 Ram Service Truck?
- Q&A: Replacement Jack Screw and Nut Kit for a 12K Bulldog Jack
- Q&A: Replacement Door Parts for Featherlite Trailer
- Q&A: Replacement Cap for Dexter A-60/A-75 Actuator
- Q&A: How Does the Pipe Attach to the Cam Lock Assembly on Polar 658-002?
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Replace an RV Roof Vent Cover
- Article: Slipper Spring Trailer Suspension System Review
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Tire Sizing