Recommended Friction Bar Sway Control For 1-1/4 Inch Receiver With Ball Mount In Rise Position  

You will want to use Curt Friction Sway Control #17200. I confirmed with Curt and they gave it the go ahead saying they have not had any issues with it being used in that configuration. You will need Reese Sway-Control Bracket for 1-1/4"…

Weight distribution systems are only available for vehicles with a Class III or higher rated hitch with the 2 inch receiver, not the 1-1/4 inch receiver on a Class I or Class II hitch. Your best bet would be to replace your existing hitch with a…

The trailer hitch that I recommend for your 2018 Mazda CX-9 is the Draw-Tite Max-Frame Trailer Hitch Receiver #76020. This is a Class III hitch with a 2" receiver that has a max gross trailer weight of 4,500 lbs and a max tongue weight of 675…

If your 2-5/16 inch ball has a 1 inch diameter shank, it will fit in the Reese Sway-Control Bracket, #RP26003, which you referenced. However most have a 1-1/4 inch shank. If you need a properly sized ball, you could use #63847. The only other bracket…

With the use of a cargo carrier a transmission cooler is not normally used, but a cooler will prolong the life of a transmission towing or not so it's a great idea for your 2014 Honda Odyssey. We installed the Derale part #D13502 on a 2014 Honda…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…