Wire Colors to Use for Installing Pop and Lock Tailgate Lock on 2010 Ford F-250
Updated 06/05/2017 | Published 06/02/2017
Question:
Trying to install the pop and lock electronic tailgate locking system in my 2010 f250. What color wires am I looking for? And where on the truck? Driver side, passenger? Im haveing a tough time locating the correct ones.
asked by: Greg
Expert Reply:
On your 2010 Ford F-250 the correct wire to use for the install of the Pop and Lock Tailgate Lock part # PAL8250 is grey with a brown stripe and light blue with green stripe on the driver side. Then on the passenger side you would want the grey with brown and purple with grey stripe.
If you check out the install video I attached you can see this kit installed on a similar truck that would be the same setup as yours.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Grille Guard
- Shop: Westin HDX Modular Grille Guard with Punch Plate - Black Powder Coated Steel
- Q&A: How Does the Pop & Lock Custom Tailgate Lock PAL8250 Install in a 2008 Ford F150
- Q&A: Wireless Camper Shell Lock for SnugTop Camper Shell
- Q&A: UFP A-60 Trailer Coupler Actuator Shock Replacement
- Q&A: What Powers the Interior Light of a Horse Trailer
- Q&A: Will the BAKFlip G2 Hard Tonneau Cover # BAK26601 Limit Trunk Access on a 2014 Honda Ridgeline
- Q&A: Installing The BakFlip F1 Hard Tonneau Cover On 2012 Honda Ridgeline
- Q&A: Does The BAKBox 2 and BAKFlip Cover Allow Access To Trunk In Honda Ridgeline
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: The 5 Best Trailer Drop Hitches You Can Buy