How to Wire In Side Marker Lights to Hopkins Endurance 4-Way Flat Trailer Wiring Harness # HM48240
Updated 03/02/2011 | Published 02/28/2011
Question:
does this wiring kit have wires to hook up the side marker lights on a 5x8 trailer? thanks
asked by: Joseph G
Expert Reply:
The Hopkins Endurance 4-Way Flat Trailer Wiring Harness, # HM48240, is a wishbone style trailer wiring harness. This means that the running light signal is split at the plug and there are two separate wires, one ran with the right turn/brake green wire and the other ran with the left turn/brake yellow wire. It does not come with additional wiring for side marker lights. If you were to wire in side marker lights, you would tap into the wire with the brown stripe for either side.
Product Page this Question was Asked From
Hopkins Endurance 4-Way Flat Trailer Wiring Harness - 20' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 4 Flat
- Plug and Lead
- Hopkins
more information >
Continue Researching
- Q&A: Replacing The Wiring Harness On A Demco Kar Kaddy SS
- Q&A: Replacement 30" Fireplace for 2012 Tiffin Phaeton
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement A/C Shroud for a Dometic Duo-Therm Model 57908.321
- Q&A: Replacement Coupler Parts
- Q&A: Disc Brake Assemblies For Changing A 12,000LB Dexter Axle To Hydraulic Disc Brakes
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Correct Bearing Kit and Brakes for Timbren Axle-Less 3,500 System with 4" Lift
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Basics of Tie Down Straps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations