Finding the Stop Light Switch Wire on a 1999 GMC Jimmy
Updated 04/27/2017 | Published 04/26/2017
Question:
what color is the wire on brake light switch on 1999 gmc jimmy as there isnt much room under dash installing brake controller from e trailer
asked by: JOSEPH C
Helpful Expert Reply:
When locating the stop light switch wire, there really is no standard wire color on any vehicle. In all reality, if the manufacturer runs out of, let's say red wire, then they will most likely just grab whatever wiring that they can to finish the job.
What I recommend doing is using a Circuit Tester # PTW2993 to test the wiring on your 1999 GMC Jimmy. You will need to make sure that you connect your brake controller to the cold side of the stop light switch. This will be the wire that only gets a signal when the brake pedal is pressed.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Article: Brake Controller Installation: Starting from Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Q&A: Will Timbren's Work with a B&W Gooseneck Hitch on a 2012 Ford F-150
- Q&A: Suspension Enhancement Recommendation for 2003 Toyota Tundra with B and W Turnoverball
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer