What is the Wire Gauge Used on Hopkins Endurance Easy-Pull 4-Way Trailer Connector # HM48138
Updated 04/11/2017 | Published 04/10/2017
Question:
Can you tell me what gauge of wire the pigtail uses? Thanks.
asked by: Matthew K
0
Expert Reply:
I went out to the warehouse to check the wire gauge used on Hopkins Endurance Easy-Pull 4-Way # HM48138. The ground wire is 16 gauge and the light wires are all 18 gauge. These are common sizes used on 4-Way harnesses.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Hopkins Endurance Easy-Pull Harness with 4-Pole Flat Connector - LED Tester - Trailer End - 12"
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 4 Flat
- Plug and Lead
- Hopkins
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Taillight Lens with SAE STIAP2 04 DOT DOT Number On It
- Article: Trailer Lighting Requirements
- Q&A: Recommended Trailer Fender for 14 Inch Wheels and 28 Inches Long
- Q&A: Fenders for 1996 EZ-Loader Boat Trailer
- Q&A: Choosing Between a Standard Trailer Fender or One with a Backing Plate
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: Outer Diameter of Deka Jacketed 4 Conductor Cable # DW04923-1
- Q&A: Recommendation for Higher Gauge Wiring to Use on Trailer
- Q&A: Dimensions of Channel Tongue Trailer Couplers for 2 Inch Frame
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)