What Size Hole Needs to be Drilled to Install a Uni-Lite Mini LED Side Marker # MCL11RKB in Trailer
Updated 02/07/2011 | Published 02/03/2011
Question:
what size hole needs drilled for the groument ?
asked by: Dan
0
Expert Reply:
I went out to our warehouse and measured a Sealed, Uni-Lite Mini LED Side Marker and Clearance Light, part # MCL11RKB, and found that you will need to have a hole that is 11/16 inches to install the # MCL11RKB.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Looking For Conventional Ramp Door Spring For 7' Wide Trailer With Extremely Heavy Door
- Article: Trailer Wiring Diagrams
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Difference Between Tire Sizes 4.80-12 and 5.30-12
- Q&A: Comparing 12" Tire Options ST145/R12 And 5.30-12
- Q&A: Diameter of the Replacement Footplate Keeper Pin for etrailer and Ram Square, Direct Weld Jacks
- Q&A: Best Lug Nuts for 2021 Keystone Cougar 29RKS
- Q&A: Axle Riser Kit for a Lippert 3500 Diamond Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)