Is 2/0 AWG Welding Cable Okay To Use For Running Two 6 Volt Batteries In Series On A Trailer?
Updated 03/29/2017 | Published 03/28/2017
Question:
I just bought two 6 volt deep cycle batteries for my trailer. I want to wire in series obviously and have some left over 2/0 welding cable I planned on using to jump the two. In order to get from one battery box to the other it has to be about 18inch long. Im guessing since its 2/0 AWG that would be OK. What do you think? Thanks
asked by: Joe
0
Expert Reply:
Yes. Your 2/0 AWG welding cable will be just fine for running your 6 volt deep cycle batteries in series on your trailer. The 18 inch length you suggested should work well.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Brass Battery Terminal Bolt Extender - Long Side Terminal - 3/8"-16 Thread x 1-13/16" Long
- Accessories and Parts
- Battery
- Bolt Extenders
- Deka
more information >
Continue Researching
- Q&A: Will # DW05418 Work With a NOCO GENPRO 10X4 # NOC84FR?
- Q&A: Recommended Cover for a 2023 Lance 2285 Travel Trailer
- Q&A: Replacement Check Valve Needed For The Demco Air Force One Supplemental Braking System
- Q&A: Can Using Heavier Gauge Wire Allow NOCO GenPro to Extend Wiring Past 10 Feet
- Q&A: Recommended Easiest Bike Rack to Load a Heavy E-Bike
- Q&A: Can Camco Pure Taste Replace Bleach To Clean A Fresh Water Drinking System?
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It