Replacement Nut and Bolt for Yakima RailGrab Towers
Updated 03/28/2017 | Published 03/27/2017
Question:
I lost a nut from one of my claws. Can you verify the thread for the bolt/nut assembly? Purchased all these from you guys back in 2014 or so. Thanks
asked by: Russell B
0
Expert Reply:
The Yakima RailGrabs, which replaced the LowRider line of towers, and is now itself discontinued, did not have any changes to the hardware over its life span so # Y8880279 will fit your RailGrab towers. If you need the wedge assembly it is # Y8880150. If you need any other RailGrab parts let me know and I can see if they are available.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement Upper Claw Base with Brass Nut for Yakima RailGrab Roof Rack Towers - Qty 1
- Accessories and Parts
- Roof Rack
- Tower Parts
- Claws
- Yakima
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Determine Which Yakima Railgrab Claw is Needed to Fit Vehicle
- Q&A: Front and Rear Hinges for a Yakima SkyBox 21 Cargo Box
- Q&A: All Replacement Parts for a Yakima Railgrab Tower
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: What Hitch For The 2026 Subaru Crosstrek Hybrid Has The Best Ground Clearance?
- Q&A: Replacement Claw Tightener for Yakima RailGrab Roof Rack Towers
- Q&A: Parts Needed to Complete a Tow Package on a 2013 Kia Sportage
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver