Will Demco Reverse Lockout Solenoid Fit a UFP Actuator
Updated 02/07/2017 | Published 02/05/2017
Products Featured in This Question
Question:
Will this reverse flow solenoid work in place of the UFP solenoid on a UFP actuator?
asked by: Cory
Expert Reply:
You could get the Demco lockout solenoid # DM5404 to fit the UFP coupler. But as far as whether or not it is the right type of solenoid is what you need to look at. This one is designed to route brake fluid back into the master cylinder via a second port in the master cylinder. If that is what your UFP has then you could use this solenoid just keep in mind that it has not been tested with other brands.
If your actuator does not use the bypass type of solenoid then you would use one like # DM11993. It just stops the flow of fluid when energized. But again it has only been tested with Demco actuators.
Product Page this Question was Asked From
Demco Solenoid Kit for Brake Actuators with Reverse Lockouts - Bypass
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Solenoid
- Demco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Comparing Bypass and Non-Bypass Electric Reverse Lockout Solenoids for Surge Couplers
- Q&A: Can Dexter Drum Actuator have Electric Reverse Lock Out Added It
- Q&A: How Does The Demco Reverse Lockout Solenoid Kit DM5404 Install?
- Q&A: Replacement Brake Actuator for a 2013 Ranger Bass Boat Trailer
- Q&A: Surge Drum Brake Actuator Recommendation that Has Electric Reverse Lock Out
- Q&A: How to Tell if UFP A-160 Actuator Has Manual Lockout
- Q&A: Recommended Replacement Actuator for Reliable ACT 7.5k
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure a Trailer Axle