Installation of Kat's Heaters Custom Fit Engine Block Heater on 2010 Toyota 4Runner
Updated 01/09/2017 | Published 01/07/2017
Question:
Wont go in all the way, even after cleaning hole out. At the end of this heater theres some notches, does it fit in only one certain way or should it fit in no matter how its positioned? 2010 4Runner.
asked by: Joe
0
Expert Reply:
If you've already cleaned out the opening on your 2010 Toyota 4Runner then it's likely the Kat's Heater # KH11813 needs to be inserted a specific way. This isn't the case on all vehicles, and we haven't had the chance to install one on a 4Runner but on some it needs to be rotated to find the correct way for installation.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Kat's Heaters Custom Fit Engine Block Heater - Cartridge Style - 120V - 400 Watts
- Vehicle Heaters
- Engine Block Heater
- Cartridge Style
- 120 Volts
- 400 - 599 Watts
- Kats Heaters
more information >
Continue Researching
- Q&A: 2015 Toyota RAV4 LE Engine Block Heater Fit
- Q&A: Can The Kat's Heaters Oil or Transmission Pan Heating Pad Conform To Curved Surfaces
- Q&A: Engine Block Heater Location for a 2021 Toyota Tundra
- Q&A: Installation of Kat's Heaters Custom Fit Engine Block Heater on 2010 Toyota Corolla
- Q&A: How Long Does it Take for Kat's Heaters Oil or Transmission Pan Heating Pad to Heat Up
- Q&A: Magnetic Heater for the Oil Pan on a Log Splitter Motor
- Q&A: Installation of Kat's Heaters Cartridge Heater for 2008 Scion tC
- Article: Performance Chips and Modules
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: Brake Controller Installation: Starting from Scratch
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?